✓ Da Brim PRO Builder / Tech / Tech Lite

How to Install Your Da Brim PRO Visor

The Da Brim PRO line fits most climbing and work-at-height helmets including Kask, Petzl, 3M, MSA and Edelrid. Follow these steps for a secure, safe fit.

✓No tools required

Fits Kask, Petzl, 3M, MSA

Da Brim PRO visor attached to a construction helmet

Step-by-Step Installation

Begin with a Loose Adjustment Strap

Start with the adjustment strap fully loosened so the band is at its widest.

💡 Tip: If your helmet has a removable visor, remove it before installing the Da Brim. This product should not be used with helmets that have a non-removable visor.

Hold the Helmet and Position the Band

Hold your helmet at the centre back with your thumb on the outside and grip the centre back loop of the Da Brim visor at the same place with your thumb.

💡 Tip: Keep a firm grip so both the helmet and visor stay aligned.

Seat the Visor on the Helmet

Place your other hand at the front of the product and rotate the assembly upside down. Push the helmet against your chest and slowly pull the visor over the helmet, seating the visor edge on the helmet. The black underside of the product should end at the bottom edge of the helmet.

⚠ Important: Failure to properly install the Da Brim could result in it unseating during use, which may lead to serious injury.

💡 Tip: Work slowly and evenly to avoid the visor sitting crooked.

Flip Over and Tighten the Strap

Flip the assembly over and tighten the strap by positioning your thumb at the rear of the helmet and pulling on the strap. Tuck the strap into the hole provided.

💡 Tip: The visor should feel snug and not wobble when you shake the helmet.

Check for Correct Installation

Centres of the helmet and Da Brim helmet visor should align; if necessary, pull to straighten. Always ensure the strap is tight. The Da Brim visor should always seat below the front helmet surface, as shown, to prevent detachment. Check by pulling upward on the front visor as if in wind flow.

⚠ Important: Failure to properly install the Da Brim could result in it unseating during use, which may lead to serious injury.

💡 Tip: If the product does not seat as described, do not use it with this helmet. Failure to properly seat the visor could result in it unseating during use and startling you or others, or obstructing your vision, which may lead to serious injury or even death.

Fit Helmet and Test Your Vision

After the visor is installed on the helmet, follow the helmet manufacturer's instructions for fitting the helmet. Then check that the visor does not obstruct your vision.

💡 Tip: Look up, down, and side to side to ensure full range of vision.

How to Remove the Da Brim

Always remove the Da Brim when stationary and in a safe location.

Wait until you are at a safe location and at a rest position.

Disengage the visor by releasing the tension on the strap. Pull up on the buckle.

Pull up on the visor and remove it from the helmet.

Important Safety Information

The PRO line is designed for climbing and work-at-height helmets only. Do not use with standard hard hats or billed helmets.
Do not modify the Da Brim or use it with helmets it was not designed for.
Always inspect hook and loop fasteners regularly for wear. If they do not function properly, discontinue use.
Always make sure the straps on your helmet are tight, as per the helmet manufacturer's instructions.

Shop the Da Brim PRO Range

Builder, Tech and Tech Lite — sized and styled for the job site.

View Product View FAQ